Smart Defrag 1.50 language

[DJohn10589]

How do I change the language. I used Advanced SystemCare 3.8.0 Pro. When I try to run Smart Defrag (1.50) the screen uses mostly cyrillic characters. I don't know what language it is. How do I switch to English?

[Toppack]

In SD version 2.0.1 the language is changed in 'Settings' >> 'User Interface' page >> Language.

There's 'been to much software under the bridge' to remember about V1.5, but I think it was similar.

If you can't read the menus to select the proper one, you may just have to try them until the correct one is found.

 

If you find that it is already set to English, you might try changeing to some other language and then back to English again, to correct it.

That should reset the config file.

 

If that does not work you may need to Re-Install or install the latest version.

[DJohn10589]

Thanks Toppack. I tried all the links. None led to settings or language as far as I could tell. I've downloaded the newer version. Thanks.